Completed the Waist Frame assembly of the MGEX Strike Freedom (changlong) Model Part 1

    To assemble this waist frame. I have prepared the following parts: A (Multicolor), B (Golden Gold), C (Bronze Gold), F1 (Metallic Gray), G (Gold), L1 (Red), L2 (Red), Metal 3D Sticker.

This is my finished video of the mgex strike freedom waist frame.

I assembled the left side, part number G-4 and above the pin of Part number G-5, part number A-16 was assembled to the bottom of the pin of part number G-5. Then assembled part number G-6 to the other side of part number G-5. The other side was assembled the same as above. Assembled this finished part into Part number F1-17, assembled part number F1-16 to the other side matching the joint of part F1-17.

MGEX Strike Freedom - Part G-4, Part G-5 and Part A-16

MGEX Strike Freedom - Left Part G-4, Part G-5 and Part A-16 

MGEX Strike Freedom - Part G-6 

MGEX Strike Freedom -Part G-6 

MGEX Strike Freedom - Right Part G-4, Part G-5 and Part A-16 

MGEX Strike Freedom -Part G-6 

MGEX Strike Freedom -Part G-6 

MGEX Strike Freedom -Part G-6 

MGEX Strike Freedom -Part F1-17 

MGEX Strike Freedom -Part F1-17

MGEX Strike Freedom -Part F1-16

MGEX Strike Freedom -Part F1-16

For this part I assembled part number G-7 into the hole of part number C-16 on the left and installed Part G-7 into the hole of part number C-15 on the right. Then installed these 2 finished parts into the left and right pins of Part number A-7. Assemble finished part 1 above into the pin of finished part 2 below.

MGEX Strike Freedom -Part G-7 x2, Part C-16 and Part C-15

MGEX Strike Freedom -Part C-16 and Part C-15

MGEX Strike Freedom -Part A-7

MGEX Strike Freedom - finished part 1 and 2

MGEX Strike Freedom - finished part 1 and 2 connect

MGEX Strike Freedom - finished part 1 and 2 complete

In Waist Frame Part 1 will be used for my next assembly in Part 2.