I have prepared the following parts: D (White Gold), E (White), J1 (Light Gray), L1 (Red) and the Head Frame has been fully assembled.
This is my finished video of the mgex strike freedom head armor.
I have assembled part number E-1 at the front, part number E1-5 is assembled on the right side of the frame, part number E1-4 is assembled on the left side of the frame, part number J1-1 is assembled at the bottom rear, part number J1-2 is assembled above part number J1-1, and part number E1-2 is assembled at the very top.
MGEX Strike Freedom - Part E-1
MGEX Strike Freedom - Part E-1
MGEX Strike Freedom - Part E1-5 and Part E1-4
MGEX Strike Freedom - Part E1-5 and Part E1-4
MGEX Strike Freedom - Part E1-5 and Part E1-4
MGEX Strike Freedom - Part J1-1
MGEX Strike Freedom - Part J1-1
MGEX Strike Freedom - Part J1-2
MGEX Strike Freedom - Part J1-2
MGEX Strike Freedom - Part E1-2
MGEX Strike Freedom - Part E1-2
In the next step, I assembled part number E1-3 at the front, part number D-1 was installed on top of E1-3, and part number L1-1 was placed at the very top to hold the other two parts in place and prevent them from falling out.
MGEX Strike Freedom - Part L1-1, Part E1-3 and Part D-4
MGEX Strike Freedom - Part L1-1
MGEX Strike Freedom - Part D-4
MGEX Strike Freedom - Part L1-1
MGEX Strike Freedom - Head Armor complete
In this assembly section, there aren't too many parts that make it difficult for me to assemble; I just need to pay attention to the final assembly of part L1-1, as this part is small.