The Beam Rifle Right Unit of the MGEX Strike Freedom has been fully assembled

In the final assembly of this Beam Rifle Right I have prepared the following parts: A/A2 (Multi-colored), D (White Gold), F1 (Metallic Gray), Part F2 (Metallic Gray), E1 (White), E2 (White), I1 (Blue), I2 (Blue), L1(Red), L2(Red), SB1 (Clear pink), x2 Beam shields, metallic 3d stickers and Beam Rifle 1 complete.

Here is my finished video Weaponry part beam rifle right of the mgex strike freedom. This assembly part runs from the 6th minute to the 13th minute.

After preparing the parts to be disassembled from the frames, I pasted the metallic 3d sticker number 32 on the inside of F2-33, then assembled part number A2-4 on the inside of part number F2-33, assembled this completed part into the left rear pin of part number F2-35, then part number F1-24 was assembled into the right lower pin of part number F2-35. Assembled the completed beam rifle 1 part into the inside of part number F2-35, assembled part number F2-34 to the outermost side. Pasted the metallic 3d sticker number 23, 24 and the left triangular empty frame side of part number E1-46, the metallic 3d sticker number 25, 26 was pasted on the right side of part number E1-46. Assembled part number E1-46 on top of the completed part. Assembled part number I1-3 on top. Stick the metallic 3d sticker on the front of the sight, assemble part number L1-7 into the front of the sight, part number A2-2 is installed inside the sight. Finally assemble part number F1-22 into the right outer pin.