In the final assembly of this Beam Rifle Left I have prepared the following parts: A/A2 (Multi-colored), D (White Gold), F1 (Metallic Gray), Part F2 (Metallic Gray), E1 (White), E2 (White), I1 (Blue), I2 (Blue), L1(Red), L2(Red), SB1 (Clear pink), x2 Beam shields, metallic 3d stickers and Beam Rifle 1 complete.
Here is my finished video Weaponry part beam rifle left of the mgex strike freedom. This assembly part runs from the 13th minute to the 17th minute.
In this assembly part, I prepared part F2-24 to assemble into the pin of part number F2-30, the finished part beam rifle 1 is assembled into the middle of part number F2-30. Part number F2-32 is assembled into part number F2-31. Then I placed this part at the end of part number F2-30. I pasted metallic 3d decal sticker number 23,24 on the left triangle frame of part number E2-46, on the right side of part E2-46 I pasted metallic 3d decal sticker number 25,26 on the triangle frame. After finishing the decal, I assembled part number E2-46 on top of the beam rifle, part number I2-3 was assembled right next to part number E2-46. I pasted metallic 3d sticker number 31 on the holo tube part, then I assembled part number L2-7 on the outside, part number A2-2 looks like a small blue glass, quite small so I prepared carefully to install inside part number L2-7, at this assembly step I was almost done, now only part number F2-22 left, I assembled it on the left outer pin part of the beam rifle.
